Skip to main content
Took off clamps and screws after gluing up companionway hood. Used a hand saw to trim the edges. There was a lot of overhang. I have seen this in other blogs of kit builders. Then used a rasp and finally power sanders to finish the job. Next to give it a coat of fiberglass. Pictures below of the dry fit of hatch cover and companionway hood.

Comments

Popular posts from this blog

Bowsprit install.

Bowsprit install.
Had to add this link to YouTube videos of pocketship perfecto for future reference. https://m.youtube.com/watch?v=giYUtFamjcU https://m.youtube.com/watch?v=giYUtFamjcU

Painting the final coat on bottom Starboard side.

Painting the final coat on bottom Starboard side.